YEAR: 1977
Material: Cr-Hr-Hrpu-Hsla Weight Capacity: 45,000 Lbs. Width: 60" Coil O.D.: 72" Coil I.D. Entry: 24" - 30" I.D. Exit: 20" and 24" Line Speed: 250 FPM and 750 FPM Constant Operating Modes: Pull Thru - Drive Assist - Loop Line Direction: Right to Left
Consisting of the following:
-Entry Pit Type Coil Car: Self-Contained Hyd. Power Unit Hydraulic Lift & Travel Coil Saddles
-Mandrel Uncoiler: Overarm Holddown Roll - Powered Hydraulic Expansion Slide Base Water Cooled Brake Hydraulic Motor Feedup
-Entry Unit: Peeler Table with Hydraulic Lift and Extend Photo Eye Edge Detector 5 Roll Flattener with Pinch Rolls Roller Type Side Guides Crop Shear
-Feedup Table: Drop Away Type for Crop Removal Cropped End Scrap Bin
-Injector Type Slitter Heads: (2) Heads 9" Dia. x 66" Face Arbors Single Eccentric Arbor Adjustment Overhead Cylinder set up to move Heads in & out DC Drive Motor thru Right Angle Reducer
-Dual Scrap Winder: Inspection Table over the top Bottom Drop out of the Scrap Ball Hydraulic Motor Wind Hydraulic Cylinder Level Wind
-Pit Cross Over Table:
-Tension Stand: Entry Separator Tooling Bar Pad Type Tension Unit Air Brag Type Tension Control Exit Pinch Rolls with Tach Threading Table
-Recoiler: 20" Dia. Drum Hydraulic Grip & Expand Hydraulic Pushoff Overarm Separator 200 Hp DC Main Motor, 650/1950 Rpm Integral 2 Speed Reducer with 47:1 and 16:1 Ratios -Floor Mount Coil Car: Keeper Arms Self-Contained Hydraulic Power Unit Side Mast Design
-2 Arm Exit Turnstile: Mechanical Pushoff
-Line is installed, but not under power.
|