Hand of Operation: Right to Left
Model: W20
Shaft Diameter: 2"
Maximum Tube Diameter: 3"
Minimum Tube Diameter: 0.500"
Maximum Wall: 0.134" Mild Steel
Minimum Wall: 0.018" Mild Steel
Gearbox Data:
Spindle Diameter: 2"
Roll Space Forming: 1-2: 10"
Roll Space Forming: 3-4: 8"
Roll Space Fin & Size: 4"
Horizontal Centers: 15"
Maximum Line Speed: 300 FPM

Consisting of the following:

-6,000 lbs. Littell Double End Uncoiler:
Serial #800-0
6,000 lbs. Each Side
Max. Coil Width: 12"
Hydraulic Expansion & Feedup
ID: 19" - 24"
OD: 72" Max.
Air Brakes

-Guild Shear & End Welder:
Max. Strip Width: 11"
Max. Strip Thickness: 0.125"
Miller Syncrowave Power Source, Model: 250
Hydraulic Shear & Clamps
Tig Torch

-Kent R22 Vertical Floop:
Strip Width Range: 3" - 10"
Gauge Range: 0.049" - 0.134"
Maximum Yield: 50Ksi Yield
Maximum Mill Speed: 300 FPM
Hand of Operation: Right to Left

-Forming Mill - Yoder W20:
Serial #Y-2708
(1) Entry Guide Table with Edge Trimming
(3) Driven Breakdown Stands
(5) Idle Side Rolls with Vertical Adjustment & Top Straps
(3) Driven Fin Stands
(1) Mandrel Bracket

-Weld Area:
(1) Thermatool 3 Roll Weld Pressure Unit
(1) Chip Breaker
(1) Seam Ironer Unit
(1) Single Scarfing Unit

-200 KW Solid State Induction Welder:
RK 200 KW Welder (New)

-Coolant Zone:
15' Trough

-Sizing Mills - Yoder W20:
(4) Driven Sizing Stands
(4) Idle Side Rolls with Vertical Adjustment & Top Straps
(2) Double Sided Turkshead - 8 Roll
(1) Measuring Wheel Assembly

-RK Flying Saw (New):

-Mill Drive:
(2) 50 HP DC Motors (Breakdown & Fins)
(1) 75 HP DC Motor (Sizing)
All motors have 2 Speed Reducers & Chain Drive

-Miscellaneous:
-Coolant Filtration Unit with Storage Tank
-Dual Wire Remetalizing Unit (New)
-Remetalizing Chamber (New)
-Entry Strip Cleaning System (New)
-Pruftechnik Eddy Current Tester (New)
-High Temp Washer (New)
-UV OD Paint System
-ID Painting System (New)
-Kent Burrmaster
-Torit Dust Collector
-Hydraulic Power Units to operate entire line.
-New VFD Drives & Controls
-New Control Panel
-New VFD Drives and Program
-Interface Controls with HF Welder

-Tooling:
0.706 OD
0.922 OD
1.163 OD
1.510 OD
1.740 OD
2.197 OD
2.875 OD