Hand of Operation: Right to Left Model: W20 Shaft Diameter: 2" Maximum Tube Diameter: 3" Minimum Tube Diameter: 0.500" Maximum Wall: 0.134" Mild Steel Minimum Wall: 0.018" Mild Steel Gearbox Data: Spindle Diameter: 2" Roll Space Forming: 1-2: 10" Roll Space Forming: 3-4: 8" Roll Space Fin & Size: 4" Horizontal Centers: 15" Maximum Line Speed: 300 FPM
Consisting of the following:
-6,000 lbs. Littell Double End Uncoiler: Serial #800-0 6,000 lbs. Each Side Max. Coil Width: 12" Hydraulic Expansion & Feedup ID: 19" - 24" OD: 72" Max. Air Brakes
-Guild Shear & End Welder: Max. Strip Width: 11" Max. Strip Thickness: 0.125" Miller Syncrowave Power Source, Model: 250 Hydraulic Shear & Clamps Tig Torch
-Kent R22 Vertical Floop: Strip Width Range: 3" - 10" Gauge Range: 0.049" - 0.134" Maximum Yield: 50Ksi Yield Maximum Mill Speed: 300 FPM Hand of Operation: Right to Left
-Forming Mill - Yoder W20: Serial #Y-2708 (1) Entry Guide Table with Edge Trimming (3) Driven Breakdown Stands (5) Idle Side Rolls with Vertical Adjustment & Top Straps (3) Driven Fin Stands (1) Mandrel Bracket
-Weld Area: (1) Thermatool 3 Roll Weld Pressure Unit (1) Chip Breaker (1) Seam Ironer Unit (1) Single Scarfing Unit
-200 KW Solid State Induction Welder: RK 200 KW Welder (New)
-Coolant Zone: 15' Trough
-Sizing Mills - Yoder W20: (4) Driven Sizing Stands (4) Idle Side Rolls with Vertical Adjustment & Top Straps (2) Double Sided Turkshead - 8 Roll (1) Measuring Wheel Assembly
-RK Flying Saw (New):
-Mill Drive: (2) 50 HP DC Motors (Breakdown & Fins) (1) 75 HP DC Motor (Sizing) All motors have 2 Speed Reducers & Chain Drive
-Miscellaneous: -Coolant Filtration Unit with Storage Tank -Dual Wire Remetalizing Unit (New) -Remetalizing Chamber (New) -Entry Strip Cleaning System (New) -Pruftechnik Eddy Current Tester (New) -High Temp Washer (New) -UV OD Paint System -ID Painting System (New) -Kent Burrmaster -Torit Dust Collector -Hydraulic Power Units to operate entire line. -New VFD Drives & Controls -New Control Panel -New VFD Drives and Program -Interface Controls with HF Welder
-Tooling: 0.706 OD 0.922 OD 1.163 OD 1.510 OD 1.740 OD 2.197 OD 2.875 OD
|