YEAR: 1994

Strilich Cut-to-Length Line

Capacity: 48" x 0.040" - 0.190" Mild Steel
Shear Strength: 50,000 PSI
Yield Strength: 50,000 PSI
Weight Capacity: 30,000 lbs.
Line Speed: 0 - 125 FPM
Electrical Supply: 480 V/3 PH/60 Hz
Line Direction: Right to Left

Consisting of the following:

-Uncoiler: Strilich
Capacity: 25,000 lbs. x 48"
48" Face Mandrel
Coil I.D. Range: 18.5" - 24.5"
3 Segment Pumpkin Tooth Mandrel
Hydraulic Wedge Type Expansion
8" Diameter Main Shaft
Sliding Base
72" Coil O.D. Capacity
Hydraulic Motor Threading Drive
Whichita ATD-118 Kopper Kool Brake
Passline Height: 47" from Floor to center of Mandrel
Overall Size: 116" L x 60" W x 85" High

-Water Cooler

-Hydraulic Z-Type Peeler Table: 9' Long
Maximum Strip Width: 48"
Heavy Duty fabricated structural steel construction.
1" thick beveled nose reinforced peeler plate.
Heavy duty hydraulic table positioning cylinders.
Cylinders piped to valve manifold.
Free-standing operator control console.

-Adjustable Entry Guide:
Maximum Material Width: 48"
Heavy duty welded structural steel frame.
Four sided hardened guide plates are mounted on heavy duty machined
steel blocks with acme nuts.
Guides are adjusted off center line through left and right hand
acme screws via handwheel.
Makes the initial centerline threading of the lead edge into the
straightener pinch rolls easier.

-Combination Coil Breaker and Straightener on Common Base:
Maximum Strip Width Capacity: 48"
Material Thickness Capacity: 0.040" - 0.190"
Entry 6" Dia. Powered Pinch Rolls, Air Cylinder Loaded
5 Roll Coil Breaker, 2 over 3, with 5.5" Dia. Rolls
7 Roll Straightener, 3 over 4, with 4" Dia. Rolls
Exit 6" Dia. Powered Pinch Rolls, Manual Jackscrew Adjustment
Common Variable Speed Drive geared for 125 FPM Max. Roll Speed
150 HP Baldor DC Motor thru Eurodrive Reducer w/9.26:1 ratio
All Work Rolls and Pinch Rolls are chain driven.

-Flying Cutoff System:
Hydraulic Cutoff Die complete with D2 HC-HC cutoff blades.
Rack and Pinion Die Accelerator.
Indramat Closed Loop AC Servo Drive and Control.
Cutoff Die mounted on precision ball type slide ways.
Roller Sheet Support Tables supplied.
Enrty Driven Pinch Rolls.

-Main Operator's Control Station and Electrical Cabinets:
Meter which indicates machine speed in ft/Min.
Device which will permit operator to preset the number of parts
to be cut and which will then stop the machine when preset
number of parts has been obtained.

-Ancillary Items
Electrical Drive Enclosures - (2)
Electrical Transformer
Main Operators Control Station with Remote Station
Entry/Exit Hydraulic Pumping Units
Shear Head Hydraulic Pumping Unit

-Removed and in Storage: Toledo, OH.