75" x 0.250" x 80,000# Herr Voss Cut To Length Line
Ref # 10990
Click on photo to enlarge
Materials: HRS, CRS, P/O, HSLA Coil Width Range: 36" - 75" (approx.) Thickness Range: 0.090" - 0.250" Maximum Shear: 50,000 PSI Maximum Yield: 65,000 PSI Max. Coil Weight: 80,000# Coil I.D.: 20" - 36" Max. Coil O.D.: 80" Line Direction: Right to Left Sheet Length: 36" - 20' (within Tampers) Sheet Length: 36" - 30' (within Exit Conveyor) Sheet Length: 36" - 40' (with special handling) Mode of Operation: Start / Stop Line Speed: 0 - 150 FPM Max. Finished Bundle: 20,000# @ 20'
Consisting of the following:
-Entry Coil Storage Ramp: Three (3) Coils x 80,000 each Floor Mounted
-Coil Elevator: Pit Mounted Powered Lift
-Uncoiler: Floor Mounted Double Cone Type Hydraulic Feedup Motor - Each Side Wichita Water Cooled Brake - Each Side Slide Base - each head (Cylinders rebuilt in 2019) Water Cooler for Brake
-Feedup Assist Assembly: Floor Mounted Holddown with Powered Snubber Roll Tail Guard
-Peeler Unit: Extending / Grasshopper Type
-Corrective Leveler: VKL 84/3.500-17 / 5, 4 HI, RH Powered Entry Pinch Rolls Seventeen (17) Work Rolls in an 8/9 Configuration Work Rolls are currently 3.443" Diameter Five (5) Flights of Adjustable Backup Rolls 4 HI Configuration 200 HP DC Motor Machine Mounted Controls
-Carryover Table to Shear: Powered Side Guides Fixed Upper Deflector Roll Powered Bottom Feed Roll
-High Speed Shear: Down-cut Mechanical Actuation Single Rate Blade Manual Gap Adjust 40 HP AC Motor Wichita Clutch
-Stacker: "Slide-Out" Drop Type Powered "Kick-Out" Rolls into Stacker Powered Side Tampers Powered End Stop Split Powered Roller Conveyor
-End Discharge Conveyor: Idler Roller Top Four (4) Braking Sections 60' Long x 46" Wide
-Hydraulic System: Central Hydraulic Power Unit Valve Bank
-Electronics: AC/DC Cabinets Parker DC Drive (New in 2012) Misc. Transformers
-Misc. Operators Control Consoles: Main Console with Touch Screen Controls
-Drawings and Manuals
-Spare Parts: Uncoiler Wear Plates Four (4) New Corner Jacks for the Leveler Spare DC Motor for Leveler Spare Distribution Box for Leveler (completely rebuilt) Thirty-Five (35) Usable Spindles for Gearbox (some used some new) Thirteen (13) Work Rolls (3.400" Diameter, need to be reground) Ninety-Five Backup Bearings (6.218" Diameter) Ten (10) Leveler Backup Bearing Flight Blocks Spare Motor for Shear Two (2) Spare Blades for Shear Spare Guide Rolls for Stacker
Your machine has been added to the Cart.
Click the Checkout button below or continue adding machines to the Cart.
Shopping Cart Help
To Add A Machine: While viewing the specifications of a machine, click "Add Machine to Cart".
To Submit Your Request: Click on "Checkout", then fill out the form with your contact information, and click "Submit".
To Remove A Machine: Click on "Checkout", then click the "Remove" button next to the machine you wish to remove from your Shopping Cart.