|
-Weight Capacity: 20,000#
-Material Thickness: 0.008" - 0.125" Mild Steel
-Line Direction: Right to Left
Consisting of the following:
-2 Arm Storage Turnstile: Yoder
-Combination Coil Car/Tipper: Yoder/Braner
Twin Hyd. Cylinders for Coil Lift
Twin Hyd. Cylinders for Coil Tipping
Self-Contained Hydraulics
-Uncoiler: Yoder
15.50" - 20" Hydraulic Expansion
4 Segment Mandrel
Hydraulic Sliding Base
Water Cooled Brake
Hydraulic Motor Threading Drive
-Edge Control: Yoder
-Slitter Head: Yoder
Entry Side Guides, Manual Adjustment
Entry Pinch Rolls
6.00" Diameter Arbors
Parallel Arbor Adjustment by Handwheel
Exit Passline Rolls
10 HP AC Motor Threading Drive
Eddy Current Helper Drive
-Tension Stand: Custom
Pneumatic Drag Wipe Type
Entry Separator Tooling Bar
Exit Pinch Rolls
-Paper Shooter: Yoder
-Recoiler: Yoder
20,000# Capacity
16" Dia. Drum
Manual Clamp and Expansion
Hydraulic Pushoff
Hydraulic Cylinder Controlled Overarm Separator
50 HP Eddy Current Drive - New 2015
2 Speed Gearbox w/17.7:1 and 35.5:1 ratios
-Scrap Winder: Yoder
1,500# Capacity
Level Wind
Self-Contained Hydraulics
-Hydraulic Power Unit:
-Slitter Tooling Included:
-Main Operators Panel:
-All Electrics are 575 Volt, 3 Phase
Transformers included to run on 460 Volts
-Slitting Line came from a manufacturing plant was well maintained
and used very little. It was used almost exclusively on light
gauge tinplate.
-All Electric Controls and Panels have been rewired.
-Line is removed and in storage
|
