-Entry Coil Car: "L" Type Self Contained Hyd. Pushbutton Pendant Control Backplate to "V" center of platform: 42" Width of platform: 52" Motor: Approx. 7.5 HP Hydraulic motor / pump, 480 Volt
-Mandrel Uncoiler: 64" Face Mandrel 20" - 24" Expansion Range 4 Segment Mandrel Hydraulic Expansion Threading Drive Slide Base Air Brake Passline: Approx. 53" from floor to center of mandrel
-Free Standing Overarm Holddown & Peeler Table: Powered Holddown Roll 4 Roll Coil Breaker
-Hydraulic Crop Shear
-Slitter Head: (1) Removable Head 9" Diameter Arbors Entry Passline Roll Entry Edge Guides Entry Pinch Rolls - Powered Bottom arbor adjusted by jackscrews 20 HP Baldor 1760 RPM AC Feedup Drive, 220/440 V thru Alton Reducer with 31.39:1 Ratio rated at 36.8 HP, 1.0 Serv. Factor Overrunning Clutch 15 HP Reliance 1765 RPM DC Motor, Helper Drive belt driven to Pinion Stand Pinion Stand with 6:1 Ratio (Approx) Less Tooling
-Threading Table to Recoiler
-Recoiler: 20" Dia. x 64" Face Drum Manual Grip and Expansion Hyd. Pushoff Overarm Separator 200 HP DC Motor, 500/2000 RPM Reducer with approx. 28:1 Reduction Ratio Alton Reducer
-Exit Coil Car: Pit Type "V" Platform: 20" from edge of platform to center Platform Width: 65.50" 7.5 HP, 208 / 230 / 460 Volt Hydraulic Motor / Pump Piston Length: 42" (4) 4" Dia. Guide Rods: 40" L Vertical Travel of Coil Car Platform: 20" Approx.
-Hydraulic Power Units
-Operators Control Panel
-Line Speed: 90/370 FPM (Bare Drum Speed)
-Line Direction: Right to Left
-Line is in storage: Rockford, IL
Your machine has been added to the Cart.
Click the Checkout button below or continue adding machines to the Cart.
Shopping Cart Help
To Add A Machine: While viewing the specifications of a machine, click "Add Machine to Cart".
To Submit Your Request: Click on "Checkout", then fill out the form with your contact information, and click "Submit".
To Remove A Machine: Click on "Checkout", then click the "Remove" button next to the machine you wish to remove from your Shopping Cart.